
Lift car for an office centre
In a 12-stop office building, this car carries thirteen people per trip. The lobby is busiest in the morning and evening, so we calculate the passenger traffic first and only then choose the finishes.
Open in 3DView from the car. Rendering
2For an office building
Deep thirteen-person car
The car has black doors and a black car operating panel, with two light strips on the black ceiling. The finish is restrained, with no advertising on the walls.

| Load | 1000 kg, 13 persons |
|---|---|
| Stops | 12 |
| Lift car | 1100 × 2100 mm, outer dimension per the manufacturer’s table |
| Series | Style Nature |
| Car walls | Nature oak (NA01) |
| Ceiling | L21: two light strips, Night Black |
| Floor | Natural granite 20 mm, pearl grey |
| Mirror | Narrow strip in the middle of the rear wall |
| Doors | Factory painted, RAL 9005 |
| Car operating panel | Black Granex stainless steel (X24), TFT-100E display |
| Options | EN 81-70 accessibility, energy recovery, traffic analysis, position indicator above the doors |
Traffic analysis for an office building
For a large building, we calculate handling capacity before choosing materials, so a traffic analysis has been ordered for this option. The number of people on the floors determines whether one thirteen-person lift is enough or a group is needed, and what speed to choose. For MP GO this is 1.0 or 1.6 m/s, with 2.5 m/s as an option.
The car is deep, 1100 × 2100 mm outer dimensions, with a 900 mm clear opening. This format fits into a 1600 mm wide shaft, which matters where a wider shaft cannot be built. If there is room, you can choose a wider car in the configurator and compare the options. For 12 stops, the final layout is determined by calculation.
Options for a business centre
- Energy recoveryAn option for heavy traffic and high travel. The system returns the energy released during braking.
- Remote monitoringThe ecoGO controller can be connected to the sigma4lifts platform to monitor the lift in real time, receive fault notifications and run diagnostics. The scope depends on the option ordered.
- TFT-100E displayThis is the largest screen in the MP range, with an information area, set in a black Granex panel. The floor number is visible even from the far corner of the car, and building announcements can be shown on the screen.
Why dark panels and black doors
The dark Style Nature NA01 oak-effect panels make the deep car look like a meeting room, and a narrow mirror in the middle of the rear wall makes it look shorter. The doors are factory painted in black RAL 9005, and the X24 panel is made of black Granex stainless steel. Marks from street shoes are less visible on G03 pearl grey granite. Two L21 light strips on the black ceiling give crisp light, so the car does not feel like a hospital lift.
The EN 81-70 option is enabled here too. An office with visitors usually needs Braille and voice announcements, and adding them after installation is harder than planning for them from the start.
Office and administrative buildings
According to the manufacturer, these projects were carried out by MP itself.
- 60unitsNATO HeadquartersBrussels. MP lifting equipment in a building of about 250,000 m².
- 7unitsPort HouseAntwerp, architect Zaha Hadid. MP lifts and platforms.
- 2022yearOffice buildingKyiv, Desiatynna Street. Several MP lifts, as reported by the factory.
43D configurator
Show the car to the building owner
The link to this car saves all the settings. For a traffic analysis, we need the number of floors and the number of people in the building.
Open the 3D configurator