Semicircular panoramic car
The semicircular Bohemia car has a rear section of 180° curved glass and solid side walls. The doors open into the building, and the glass faces the view or a large hall.
Open in 3DView from the car. Rendering
2For a country estate, resort or restaurant with a view, as a bespoke project
Semicircular car with 180° curved glass
The figures in the table are approximate. The engineer calculates the shape, dimensions and shaft for your site.
| Load | 800 kg, 10 persons |
|---|---|
| Stops | 3 |
| Appearance | Bohemia: semicircular, 180° glass |
| Car walls | Satin plus stainless steel (X16) |
| Ceiling | L40: four spotlights, satin plus stainless steel |
| Floor | Natural granite 20 mm, white crystal |
| Doors | Mirror-polished stainless steel (X12) |
| Opening | Centre-opening |
| Car operating panel | Satin plus stainless steel (X16) |
| Shaft | Self-supporting steel frame, clear glass |
How Bohemia differs from Murano
Murano has three flat glass walls with corners between them. In Bohemia, the rear of the car is a semicircle of continuous curved glass, so there are no corners. This car is worth installing where there is a fine view behind the glass, for example mountains, a park, water or a large hall.
The side walls are solid, made of X16 satin stainless steel; they carry the car operating panel and conceal the mechanics. The lobby is visible through the glazed Big vision doors. The ceiling is satin, with four L40 spotlights, and the floor is “white crystal” granite.
Bohemia and Sowerby
These are two MP types with the same glass angle, differing in car details and cladding.
Questions about the semicircular car
Why is 800 kg stated here?
800 kg is the initial semicircular-car configuration for display. A special panoramic car is not selected from a table, so we agree the load, shape and doors with the manufacturer for your project.
Can this glass be tinted?
The manufacturer’s catalogue specifies clear curved glass for this type. If you need a different tint, we will ask the factory, as that requires a separate calculation.
Where can such a car be installed?
Usually in its own glass shaft on a steel frame, because brick or concrete would block the whole view. The frame is calculated separately, and we carry out the building works with our own crews.
43D configurator
Bohemia car in 3D
You can view the car from all sides and show mountains, a park or your own photo behind the glass. If this option suits you, we will start with a sketch, and the manufacturer will confirm the final shape.
Open the 3D configurator